ELECTRONIC VARIATOR FOR 12V MOTOR

The inverter will have two connection systems: input, where the battery will be connected through an internal XT90 female connector, compatible with our battery models. And output, which will be connected to the motor you want to use to proceed to its control through an internal male XT90 connector. Both are identified on the housing.

It also has an optional and additional man overboard connection system. It works by connecting it directly to the jack output, when the button is in position (o). In the event of an emergency, it will automatically disconnect in the event of an outboard fall. This system includes a safety lanyard.

The remote control can be re-synchronised by pressing once on the hole marked for this purpose on the housing (when the red light comes on), press the power button on the remote control for 3 seconds (it will flash 3 times and beep to indicate a successful link). More than 1 remote control can be synchronised at the same time on the same inverter.

The remote control has three control buttons:

STOP button: Stops the motor whatever the direction of travel and speed of the motor.

Power increase button +: Increases the power progressively forward from 0 to 100%.

Decrease power button -: Progressive decrease of power backwards from 0 to 50%.  For safety reasons, the reverse power is limited to 50%.

COMPATIBLE AND TESTED WITH ENGINES OF:

-Float Plus version 1

-Minnkota End

-Minnkota Endura 30lb

-Minnkota endura 40lb

-Motorguide R3 30lb (Motor fuera borda eléctrico 12v)

Technical data sheet

Capacity
    60A
Rated voltage
    12.6V
Dimensions
    12 x 65 x 45 cm
Weight
    0.20g